Filter
Top Products
Playing The Radio
1. Press POWER to turn on the stereo.
2. Press BAND to select the AM or FM band. AM 1 or AM 2 appears on the
display when an AM band is selected. FM 1, FM 2, or FM 3 appears on
the display when an FM band is selected.
Notes: Each time you press BAND, the radio tunes to the last station
selected in the band.
[ST] appears on the display when an FM signal is received in
stereo.
3. Tune to the desired station in one of the following ways.
Manual Tuning: Repeatedly press TUNE \/ or TUNE /\ to tune down or up
the selected band.
Seek Tuning: Hold down SEEK \/ or SEEK /\ for about 1 second to tune
to the next lower or higher station.
Note: If the stereo does not find a strong station when seeking, it
searches the band again for weaker stations.
4. Press /\ or \/ to increase or decrease the volume as desired.
Notes: See "Adjusting the Controls" above for information about changing
the stereo's other settings.
To temporarily display the frequency of the station currently
playing, press F/C. The display shows the frequency for about 5
seconds, then returns to the clock display.
Memory Tuning
You can manually store up to 12 AM and 18 FM stations in memory groups.
Each memory group (AM 1, AM 2, FM 1, FM 2, and FM 3) holds up to six
stations. You can also automatically store stations into a memory group.
Manually Storing Stations
1. Repeatedly press BAND to select the desired memory group (AM 1 or AM 2
for AM, or FM 1, FM 2, or FM 3 for FM).