Onkyo TX-SR606 Stereo Receiver User Manual


 
80
Advanced Setup
—Continued
Zone 2
See “Zone 2” on page 83.
Tuner
AM Frequency (on some models)
See “AM Frequency Step Setup (on some models)” on
page 51.
SAT Radio Mode (on North American model)
If you connect a SIRIUS Satellite Radio antenna to the
AV receiver, set this setting to SIRIUS. Otherwise, select
None. See the separate Satellite Radio Guide for more
information.
Antenna Aiming (on North American model)
The ID of the Sirius Connect Home Tuner is displayed
here. You must sign up to obtain a SIRIUS ID. See the
separate Satellite Radio Guide for more information.
SIRIUS Parental Lock
(on North American model)
This item is for use with SIRIUS Satellite Radio. It’s not
available if SAT Radio Mode is set to None. See the sep-
arate Satellite Radio Guide for more information.
Analog Multich
Subwoofer Input Sensitivity
Some DVD players output the LFE channel from their
analog subwoofer output at 15 dB higher than normal.
With this setting, you can change the AV receiver’s sub-
woofer sensitivity to match your DVD player. Note that
this setting only affects signals connected to the AV
receiver’s MULTI CH SUBWOOFER jack.
You can select 0dB, 5dB, 10dB, or 15dB.
If you find that your subwoofer is too loud, try the 10 dB
or 15 dB setting.
HDMI
Output Resolution
You can specify the output resolution for the HDMI out-
puts and have the AV receiver upconvert the picture res-
olution as necessary to match the resolution supported
by your TV.
See the “Video Resolution Chart” on page 102 to see
how the AV receiver handles video input at different res-
olutions.
Through:
Select this to pass video through the AV
receiver at the same resolution and with no
conversion.
Auto:
Select this to have the AV receiver automati-
cally convert video at resolutions not supported
by your TV.
480p (480p/576p):
Select this for 480p or 576p output and video
conversion as necessary.
720p:
Select this for 720p output and video conver-
sion as necessary.
1080i:
Select this for 1080i output and video conver-
sion as necessary.
Zoom Mode
This setting determines the aspect ratio that will be used
for 480i, 480p, 576i, and 576p input signals when they
are output by the HDMI OUT. This setting only applies
when the HDMI Output Resolution setting is set to 1080i
or 720p.
Normal:
Full:
2
Use the number buttons to enter
ID 1, 2, or 3.
The Remote indicator flashes twice.