Onkyo TX-SA705 Stereo Receiver User Manual


 
81
Advanced Setup—Continued
Speaker Level Calibration
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Notes:
The speakers cannot be calibrated while the output of
the AV receiver/AV amplifier is muted.
The test tone is output at the standard level for THX,
which is 0 dB (absolute volume setting 82). If you nor-
mally listen at volume settings below this, be careful
because the test tone will be much louder.
Notes:
This procedure can also be performed by using the
[TEST TONE] button, [LEVEL–] and [LEVEL+] but-
tons. First press the [TEST TONE] button to output
the test tone. Use the [LEVEL–] and [LEVEL+] but-
tons to set the volume, and use the [CH SEL] button to
select the speakers.
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
This setting is set automatically by the Automatic
Speaker Setup function (see page 54).
2-5
1
2, 3
1, 6
ENTER
ENTER
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [ ]/[ ]
buttons to select “4. Level Cali-
bration,” and then press
[ENTER].
The Level Calibration menu appears
and the pink noise test tone is output by
the front left speaker.
Note:
Speakers that you set to No or None on
the Speaker Configuration page
(page 77) cannot be selected.
4
Use the Up and Down [ ]/[ ]
buttons to select each speaker,
and use the Left and Right [ ]/
[ ] buttons to set the volume.
The volume can be adjusted from –12
to +12 dB (–15 dB to +12 dB for the
subwoofer) in 1 dB steps.
5
Repeat step 4 until the volume of
the test tone from each speaker
is the same.
6
Press the [SETUP] button.
The setup menu closes.
ENTER
ENTER
2–4. Level Calibration
Left 0dB
Center 0dB
Right 0dB
Surr Right 0dB
Surr Back R 0dB
Surr Back L 0dB
Surr Left 0dB
Subwoofer 0dB
ENTER
ENTER
TX-SR705_En.book Page 81 Monday, May 28, 2007 2:13 PM