Filter
Top Products
100
Zone 2—Continued
To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select “2. Zone2,” and
then press [ENTER].
The Zone2 menu appears.
4
Use the Left and Right [ ]/[ ]
buttons to select:
Not Act: ZONE 2 SPEAKERS termi-
nals deactivated.
Act: ZONE 2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see below), the speakers connected to
the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURR BACK SPEAK-
ERS terminals do not (when Zone 2 is
activated but not used, the surround
back speakers work as normal).
ENTER
ENTER
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
ENTER
ENTER
7–2. Zone2
Powered Zone2 Not Act
5
Press the [SETUP] button.
The setup menu closes.
TX-SR705_En.book Page 100 Monday, May 28, 2007 2:13 PM