Filter
Top Products
57
Erasing all codes and operations programmed in
the buttons
This procedure will erase all remote controller codes for the other
devices and all macro operations that have been programmed in the
RC-392M (see pages 52, 54 and 55).
1. Open the battery cover and remove the batteries.
2. While pressing and holding down the POWER ON button
and the POWER STNBY button, insert the batteries in the
correct direction.
After inserting the batteries, release the buttons. The SEND/
LEARN indicator flashes slowly.
3. Press the ENT button.
The SEND/LEARN indicator lights up for about ten seconds,
then turns off.
All programmed codes are erased and the button memories re-
turn to the factory presets.
Note:
• Proceed to Step 3 immediately after Step 2. Otherwise, the batteries will
be consumed quickly.
• If you press any button other than the ENT button in Step 3, no codes
will be erased. In this case, repeat the steps from the beginning.
2
3
Using a Macro function