Filter
Top Products
49
Using the remote controller
Overview
When you use a remote controller, typically you press one of the MODE buttons that corresponds to the device you wish to control, then press
the operation buttons. For example, if you wish to control the TX-DS777/TX-DS676 from a remote controller, first press the MODE AUDIO
button, then press an appropriate operation button. To control a CD player, press the MODE CD button, then press an appropriate operation
button.
First, press the desired MODE button to make sure that the TX-DS777/TX-DS676 is set to a correct mode.
Using the RC-392M to control each device
Turning the power on and off to the TX-DS777/
TX-DS676
Note:
Before operating the RC-392M, turn on the POWER switch on the
TX-DS777/TX-DS676 so that the unit enters standby mode.
1. Press the MODE AUDIO button.
2. Press the POWER ON button.
Pressing the POWER STNBY button will activate the power
standby mode.
SEND/LEARN indicator
This indicator acts as a guide when commands are programmed
into or sent by the remote controller. It also warns the user when
an error is made or battery power is low.
Controlling the TX-DS777/TX-DS676
1. Press the MODE AUDIO button.
2. Press the desired operation button.
Shaded buttons in the figure are the operation buttons used
to control the TX-DS777/TX-DS676.
SLEEP : Sleep function
POWER ON/STNBY
: Power on/standby
DISPLAY : Changing the display
VOL ∆/∇ : Adjusting the volume
CH +/- : Tuner preset number increment/decrement
INPUT SELECTOR
Listening mode
: Changing Listening mode
SP A/SP B : Switching between Speakers A and B
CH SEL : Selecting a speaker
DIMMER : Adjusting the brightness of the display
LEVEL +/- : Adjusting the speaker levels
TEST : Test tone
MUTING : Muting
LIGHT : Illuminating the buttons.
MODE AUDIO
POWER
STNBY
POWER ON
SEND/LEARN
indicator
MODE
AUDIO
CH +/–
SP A/B
DISPLAY
POWER
ON/STNBY
VOL
MUTING
Listening
mode
LEVEL +/–
DIMMER
CH SEL
INPUT
SELECTOR
TEST
SLEEP
LIGHT