Filter
Top Products
19
Setting the speaker configuration
• Using the on-screen display
1. Press the OSD MENU button.
2. Select “Speaker Setup” and then press the right edge of the
ENTER/Cursor button.
3. Select “Config Setup” and then press the right edge of the
ENTER/Cursor button.
4. For the TX-DS676, go to the next step.
For the TX-DS777, the display shows “All Channel For THX
Speakers.”
Select “Yes” and then press the center of the ENTER/Cursor
button. This sets all the connected speakers to THX
speakers.(The following steps are unnecessary.)
Select “No” and then press the center of the ENTER/Cursor but-
ton to go to the next step.
5. Press the upper or lower edge of the ENTER/Cursor button
to set each item and then press the right or left edge of the
button to set a parameter
Subwoofer: Set whether or not a subwoofer is connected.
Yes: A subwoofer is connected.
No: A subwoofer is NOT connected.
Front : Select the size of your front speakers.
Large: Large front speakers are used.
Small: Small front speakers are used.
Center : Select the size of your center speaker.
Large: A large center speaker is used.
Small: A small center speaker is used.
None: A center speaker is NOT used.
Surround : Select the size of your surround speakers.
Large: Large surround speakers are used.
Small: Small surround speakers are used.
None: Surround speakers are NOT used.
6. Press the center of the ENTER/Cursor button, or press the
EXIT button, to exit the setup mode.
3
4
5
** Speaker Setup **
Config Setup
Distance Setup
Level Setup
Bass Peak Setup
* Config Setup *
All Channel For
THX Speakers =No
* Config Setup *
Subwoofer =Yes
Front =Small
Center =Small
Surround =Small