Onkyo TX-SR601E Stereo Receiver User Manual


 
77
Troubleshooting guide
“Not available with headphones use”
Operation not allowed because headphones are plugged into the
TX-SR701/701E/601/601E.
“Not available with Multichannel use”
Operation not allowed while the multi-channel output is being used.
“Not available in this Sp Config”
Will not work with the current speaker configuration settings.
“Not available in Zone 2 mode”
Setting not allowed because the Zone 2 mode is turned on.
“Only available with Dolby D”
No setting other than Dolby Digital can be set.
“Not available in this Listening mode”
Will not work with the current listening mode.
“Not available with this signal”
The listening mode cannot be selected with the current input source.
“Not available with Muting”
Operation not allowed because the muting is activated.
“Zone 2 is not On”
Will not work because the Zone 2 has not been turned on.
Also refer to the respective instruction manuals of the CD player,
DVD player, video cassette recorder, TV monitor, etc., that
compose your entertainment system.
The TX-SR701/701E/601/601E contains an internal microcomputer
that performs high-level operations. However, on extremely rare
occasions, noise or interference from an external source or static
electricity may cause faulty operation. If this occurs, unplug the
power cord from the wall outlet, wait five or more seconds, and then
plug it back in. This should correct the situation.
* To reset the surround mode and other settings to the factory
default settings, hold down the VIDEO 1 button with the TX-
SR701/701E/601/601E turned on and then press the
STANDBY/ON button. “CLEAR” appears in the front display
and the TX-SR701/701E/601/601E enters the standby state.
If one of the messages shown below appears