Filter
Top Products
43
Listening to the Radio—Continued
With the built-in tuner, you can enjoy AM and FM radio
stations and store your favorite stations as presets for
easy selection.
Tuning into AM/FM Radio Stations
■ Auto Tuning Mode
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
■ Manual Tuning Mode
The North American model changes FM frequency in
0.2MHz steps, 10kHz steps for AM. For other models
it’s 0.05MHz steps for FM and 9kHz (or 10kHz) steps
for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
You can also use the remote controller’s Up and Down
[ ]/[] buttons to tune the radio.
Listening to AM/FM Stations
Use the [AM] or [FM] input
selector button to select “AM” or
“FM”.
In this example, FM has been selected.
(Actual display depends on country.)
1
Press the [TUNING MODE]
button so that the AUTO indicator
appears on the display.
2
Press the TUNING Up or Down
[]/[ ] button.
Searching stops when a station is
found.
TUNING
AM
TUNING MODE
FM
or
Band Frequency
FM STEREO
AUTO
TUNED
1
Press the [TUNING MODE]
button so that the AUTO indicator
disappears from the display.
2
Press and hold the TUNING Up or
Down []/[ ] button.
The frequency stops changing when
you release the button.
Press the button repeatedly to change
the frequency one step at a time.