Filter
Top Products
42
Listening to the Radio
For AM/FM tuning to work properly, you must specify
the AM/FM frequency step used in your area. Note that
when this setting is changed, all radio presets are
deleted.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
AM/FM Frequency Step Setup
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down []/[ ]
buttons to select “8.Hardware”,
and then press [ENTER].
3
Use the Up and Down []/[ ]
buttons to select “FM/AM” (North
American/Taiwan models) or
“AM Freq” (Asian models).
(North American/Taiwan models)
(Asian models)
SETUP
RECEIVER
ENTER
4
Use the Left and Right []/[ ]
buttons to select:
(North American/Taiwan models)
200k/10k:
Select if 200k/10k steps are
used in your area.
50k/9k: Select if 50k/9k steps are used
in your area.
(Asian models)
10kHz: Select if 10kHz steps are used
in your area.
9kHz: Select if 9kHz steps are used
in your area.
5
Press the [SETUP] button.
Setup closes.