Filter
Top Products
23
Operation
Other Information
Before using
PreparationsConnections
If you have any problems with the unit, please check the troubleshooting table below first. For any
problems not covered in the table, please consult your nearest ONKYO authorized service center.
Symptom
The unit doesn’t turn on.
Sound is reproduced from
neither left or right speaker.
Sound is reproduced from
only one speaker.
No sound is reproduced
when the (wake-up) timer
operates.
The remote control doesn’t
operate.
Remedy
Insert the AC power cord (mains lead)
plug into the wall outlet (the mains)
securely.
• Check the speaker connections (see
page 14).
• Adjust the volume level (see page
19).
• Press MUTING button on the re-
mote controller to restore the sound
(see page 21).
• Turn down the volume level first,
then disconnect the headphones.
Then, readjust the volume level.
• Check the speaker connections (see
page 14).
• Adjust the sound balance (see page
20).
• Adjust the volume to the proper
level when you set the timer (see
page 19).
• Press MUTING button on the re-
mote controller to restore the sound
(see page 21) before you set the
timer.
• Replace the batteries with new ones
(see page 17).
• Operate the remote controller
within the control range (see page
17).
• Try to operate the remote control-
ler from a different angle, or remove
the obstruction.
Troubleshooting
Other Information
Cause
The AC power cord is not fully in-
serted into the wall outlet.
• The wire of the speaker cord is
touching the other jacks, connec-
tors, or metal parts.
• The volume level is turned down
to the minimum.
• The sound is muted with the mut-
ing function.
• The headphones are connected to
the PHONES jack.
• The speaker cord is not connected
properly or firmly, or is discon-
nected.
• The sound is unbalanced between
the left and right speakers.
• The volume level is turned down
to the minimum.
• The muting function was on when
you set the timer.
• The batteries in the remote control-
ler are dead.
• The remote controller is out of the
control range.
• There is some obstruction between
the remote controller and the unit.