Filter
Top Products
50
Audio Out Select
After you select AUDIO (see page 44), change the settings according to your preference.
Audio Setting
Select the output sound type by pressing
/ , then press ENTER.
→ If you do not want to make any other settings,
proceed to step 4.
3
ENTER
ENTER
Customizing the Function Settings (continued)
(Continued on
next page)
AUDIO
Dynamic Range Control
On
Karaoke Vocal
Off
Extended Audio Feature
Off
Audio Out Select
Bitstream
96k Sound
PCM
Bitstream
DVD
CD
DVD
CD
The output sound format can be changed according to your purpose and
preference by changing the sound signal conversion method.
The sound signal conversion method is selected from among the three listed
below. (Note that the three items are sound signal conversion methods, not
the sound signal format the sound signals are converted into.)
When “Audio Out Select” is set to “Bitstream,” the sound is output in the most
suitable format automatically through the speakers and output connector/
jacks. Therefore, although you can change the sound signal conversion
method using the menu, leaving the “Audio Out Select” setting to “Bitstream”
and changing the method according your purpose temporarily as described
on page 40 is recommended.
For details (tips on using of this function, sampling frequency and quantization
bit conversion table, etc.), see pages 40 and 41.
Bitstream
Normally use this setting.
96k Sound
Select when you wish to listen to sources recorded in the following
frequency/quantization bit in their original sound quality:
• 96 kHz/24 bit
• 96 kHz/20 bit
• 96 kHz/16 bit
• 48 kHz/24 bit
For instructions on how to reproduce the above original sounds, see page 40.
PCM
Select to convert DOLBY DIGITAL sound into the sound format recordable
by equipment such as an MD recorder connected to the DIGITAL
OUTPUT OPTICAL connector on the DVD Receiver (see pages 11 and
41).
(Continued from page 45)
Press / to select the item, then press ENTER.
ENTER
ENTER