Filter
Top Products
31
Basic Operation
(Continued on next page.)
D
O
W
N
U
P
DISPLAY TUNING
SPEAKER
SETUP
CH LEVEL
ENTER
PHONES
OFF
ON
STANDBY/ ON
MODE
FM MUTE
PRESET
MEMORY
DOWN UP STOPPAUSE PLAYOPEN/CLOSE
TREBLEBASS
PRESET /
MODE ADJ
MASTER VOLUME
POWER
Re - EQ
SURROUND
MODE
LATE NIGHT
INPUT SELECTOR
STANDBY
F M A MT VTAPE/MD
VIDEO 1 VIDEO 2 DV D
DSP indicator
SURROUND MODE
SURROUND
MODE
DVD Receiver
Remote controller
SURROUND MODE
SURROUND
MODE
Selecting the Sound Effect
The DVD Receiver will automatically detect the sound system when DOLBY DIGITAL Surround (
DIGITAL
), DTS Surround ( ), or
PCM DIGITAL (2 channel digital stereo) is played back. The sound system appears in the DVD Receiver's display.
Lights up when PCM DIGITAL (2 channel digital stereo) sound is reproduced.
Lights up when DOLBY DIGITAL Surround sound is reproduced.
Lights up when DTS Surround sound is reproduced.
Using Onkyo's original sound effects – DSP (Digital Signal Processor) selection
While playing back sources other than DOLBY DIGITAL and DTS Surround sounds, you can select the desired DSP mode.
Press SURROUND MODE on the remote controller or DVD
Receiver repeatedly until the desired DSP mode appears
in the DVD Receiver's display.
The DSP indicator lights up when one of the DSP modes is selected.
Each press of the button changes the DSP mode as follows:
STEREO→DOLBY PRO LOGIC*→ORCHESTRA→UNPLUGGED→STUDIO-MIX→TV LOGIC→5CH STEREO
↑
* If "NONE" is set to the surround speakers’ configurations, "3 STEREO" (DOLBY 3 STEREO) appears instead of "DOLBY
PRO LOGIC.”
If "NONE" is set to the center speaker’s and surround speakers’ configurations, this selection will be skipped.
Notes
• When DOLBY DIGITAL Surround sound is reproduced, you can select only "DOLBY DIGITAL" or "STEREO."
• When DTS Surround sound is reproduced, you can select only "DTS" or "STEREO."
• When MPEG2 sound source is reproduced, no other but only “STEREO” can be selected.
SENDING/
LEARNED
DVD RECEIVER
TV
LEVEL SETUP
TITLE MENU
SURROUND
MODE
DVD TV
ENTER
RETURN
AUDIO
SEARCH
ANGLE ZOOM
CLEAR
TUNER
SETUP
VIDEO 1
TAPE
VIDEO 2
INPUT SELECTOR
OPEN/
CLOSE
DIMMER
SLEEP
DISPLAY
ON
STANDBY
POWER
SUBTITLE
CH SEL
LEVEL
TEST
TONE
231
564
89
7
0
+10
MUTING
RANDOM
REPEAT A-B MEMORY
VOLUME
PRESET
PAUSE FF
PLAYDOWN
STOP SLOW
UP
FR
CHANNEL
TV/
VCR
POWER
REMOTE CONTROLLER RC-399M
TUNER
Changing the output sound signal format
of the DVD video/audio CD
You can change the format of the sound signal
being output via the speakers and output jacks
using the menu (see page 40).
This means, for example, even if DOLBY
DIGITAL Surround sound is played by the DVD
Receiver, you can output sound to the
speakers in the 48 kHz/16 bit format, which
enables you to use the DSP sound effects
below instead of DOLBY DIGITAL Surround.