Filter
Top Products
8
Connecting to other components (continued)
Connecting the connectors
If you are using other ONKYO components equipped with connectors, you can control these
components using the amplifier’s remote controller.
Before connecting
• The amplifier must be connected in the system hookups for control operations.
• Each component has two
connectors. There is no difference between these connectors.
• The components may be connected in any order.
• The hookups on the previous page are necessary independently of the
system hookups.
The illustration below is an example of a
hookup. With these hookups, you can operate the CD
Synchro Recording; when recording a tape with this unit from the CD player, you can start recording
automatically (while the unit is in recording standby) at the same time as you play the CD (see “CD
Synchro Recording” on page 14).
For CD Synchro Recording, at least the unit, amplifier, and CD player must be connected with the
connectors.
Note
If you connect the AC power cord (mains lead) to the AC outlet of another component, the component’s
AC power cord (mains lead) must be connected to the wall outlet (the mains) to supply power to the unit.
If the component has a main power switch, it must be set to On.
Connecting the AC power cord (mains lead) to the wall outlet (the mains)
The STANDBY indicator lights
AC power cord
(mains lead)
L
R
(REC) (PLAY)
INPUT
OUTPUT
REMOTE
CONTROL
STANDBY/ON
STANDBY
STEREO CASSETTE TAPE DECK
ALBUM
DOLBY NR
REV. MODE
COUNTER RESET
REC LEVEL
CD DUBBING
FADE
CASSETTE LOADING MECHANISM
Supplied remote
control cable
remote control
cable (optional)
remote control
cable (optional)
REMOTE
CONTROL
Tuner
Amplifier
This unit
(K-505TX)
CD player
Note
An remote control
cable equipped with a
1/8 in. (3.5mm)
diameter miniature two-
conductor phone plug is
included with this unit
and with every compact
disc player and tuner
that bears the mark.