Filter
Top Products
4
Precautions
1. Warranty Claim
You can find the serial number on the rear
panel. In case of warranty claim, please report
this number.
2. Recording Copyright
Recording of copyrighted material for other
than personal use is illegal without permission
of the copyright holder.
3. Deck Location
• Do not use or leave in direct sunlight or in
other places subject to high temperature
and humidity. The unit should also not be
left in potentially hot places such as near
heating appliances. Excessive heat and
moisture can lead to internal damage and
serious malfunctions (this also applies to
cassette tapes). The recommended ambient
temperature range is 5°C to 35°C.
• Avoid damp and dusty places and locations
prone to vibrations.
• Be extremely careful with the recording/
playback heads. Clean and demagnetize
them regularly, but under no circumstances
should magnets or other metals be used
anywhere near the heads.
•
This unit is extremely sensitive to magnetic
fields, so do not use near large speakers or
other devices which generate magnetic fields.
• Hum may even be induced by magnetic flux
leakage from the power transformer in
certain amplifiers. Therefore, this unit
should also be kept clear of the amplifier.
• Do not remove the cabinet case. If any of
the internal parts are handled, there is a
considerable danger of electric shock.
4. Cassettes to Avoid:
• Cassettes with poorly formed cases that
rattle during rewind and fast forward.
• Low cost cassettes with no guide roller or
pressure pad spring should never be used
for stereo.
• C-120 cassettes because the tape and the
coating are extremely thin, distortion levels
are high. Also, even a slight stretching of
the tape will make it susceptible to being
caught up in the pinch roller and capstan.
• Endless tapes, if used for a long period of
time, can overheat.
5. Care
From time to time you should wipe the front
and rear panels and the cabinet with a soft
cloth. For heavier dirt, dampen a soft cloth in
a weak solution of mild detergent and water,
wring it out dry, and wipe off the dirt.
Following this, dry immediately with a clean
cloth. Do not use rough material, thinners,
alcohol or other chemical solvents or cloths
since these could damage the finish or remove
the panel lettering.
6. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE
FIRST TIME, READ THE FOLLOWING SECTION
CAREFULLY.
The voltage of the available power supply
differs according to country or region. Be sure
that the power supply voltage of the area
where this unit will be used meets the required
voltage (e.g., AC230V 50Hz or AC120V 60Hz)
written on the rear panel.
For British Model
Replacement and mounting of an AC plug on the
power supply cord of this unit should be performed
only by qualified service personnel.
IMPORTANT:
The wires in the mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal in the plug which is
marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal in the plug which is
marked with the letter L or coloured RED.
IMPORTANT
A 5 ampere fuse is fitted in this plug. Should the
fuse need to be replaced please ensure that the
replacement fuse has a rating of 5 amperes and
that it is approved by ASTA or BSI to BS 1362.
Check for the ASTA mark or the BSI mark on the
body of the fuse.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR
THE SOCKET OUTLET IN YOUR HOME THEN THE
FUSE SHOULD BE REMOVED AND THE PLUG CUT
OFF AND DISPOSED OF SAFELY. THERE IS A
DANGER OF SEVERE ELECTRICAL SHOCK IF THE
CUT OFF PLUG IS INSERTED INTO ANY 13 AMPERE
SOCKET.
If in any doubt please consult a qualified electrician.
For Canadian model
For models having a power cord with a polarized
plug:
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Modele pour les Canadien
Sur les modèles dont la fiche est polarisée:
ATTENTION: POUR ÉVITER LES CHOCS
ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE
DE LA FICHE DANS LA BORNE CORRESPONDANTE
DE LA PRISE ET POUSSER JUSQU’AU FOND.