Onkyo HT-RC470 Stereo Receiver User Manual


 
Advanced Operations
En-63
OSD Setup
On Screen Display
`On
`Off
This preference determines whether operation details are
displayed on-screen when an AV receiver function is
adjusted.
Even when “On” is selected, operation details may not be
output if the input source is connected to an HDMI IN.
Language
`English
, Deutsch, Français, Español, Italiano,
Nederlands, Svenska
This setting determines the language used for the on-screen
menus.
Screen Saver
`3min, 5min, 10min
`Off
With this setting, you can set the time until the screen saver
activates itself. Once active, the screen saver will go off
and the screen will return to its previous state if the AV
receiver is operated in any way.
Main Menu Hardware Setup
Tuner
AM/FM Frequency Step
`10kHz/200kHz
:
`9kHz/50kHz:
Select the frequency step according to your area.
For AM/FM tuning to work properly, you must specify the
AM/FM frequency step used in your area.
Note
When this setting is changed, all radio presets will be deleted.
HDMI
HDMI Control(RIHD)
`Off
`On
Turn this setting on to allow
-compatible
components connected via HDMI to be controlled by the
AV receiver (page 90).
Note
When the setting is set to “On” and the menu is closed, the names
of connected -compatible components and “RIHD On
are displayed on the AV receiver.
Search…(name)RIHD On
When the AV receiver cannot receive the name of the component,
it is displayed as “Player
*
” or “Recorder
*
”, etc. (“
*
” shows up
and indicates the number of components, when two or more are
received).
When an -compatible component is connected to the
AV receiver via an HDMI cable, the name of the connected
component is displayed on the AV receiver display. For example,
while you are watching TV broadcasting, if you operate a Blu-ray
Disc/DVD player (being powered on) with the remote control of
the AV receiver, the name of the Blu-ray Disc/DVD player will
be displayed on the AV receiver.
Set it to
Off when a connected piece of equipment is not
compatible or it is unclear whether the equipment is compatible
or not.
If operation is not normal when set to
On, change the setting to
Off.
Refer to the connected component’s instruction manual for
details.
When the “HDMI Control(RIHD)” setting is set to “On”, the
power consumption on standby mode slightly increases.
(Depending on the TV status, the AV receiver will enter standby
mode as usual.)
•The control does not support HDMI OUT SUB. Use
HDMI OUT MAIN instead.
When the source equipment is connected with the
connection, it may malfunction if “HDMI Control(RIHD)” is
set to “On”.
Hardware Setup
1 2 3 4 5
Setup