Onkyo HT-RC470 Stereo Receiver User Manual


 
Advanced Operations
En-59
Tip
To name a radio preset, select AM or FM, and then select the
preset (page 31).
To restore a name to its default, erase all characters with CLR,
select “OK” and then press ENTER.
Note
This setting cannot be used for the NET and USB input selectors.
Picture Adjust
Using Picture Adjust, you can adjust the picture quality
and reduce any noise appearing on the screen.
To view the TV picture while setting, press ENTER. To
return to the previous screen, press RETURN.
Wide Mode
*1*6
This setting determines the aspect ratio.
`4:3:
`Full:
`Zoom:
`Wide Zoom:
`Auto
:
According to the input signals and monitor output
setting, the AV receiver automatically selects the
4:3”, “Full”, “Zoom” or “Wide Zoom” mode. See
“Monitor Out” for details on the monitor output
setting (page 50).
Picture Mode
*1*7
`Custom:
All settings can be performed manually.
`Cinema:
Select when the picture source is a movie or alike.
`Game:
Select when the video source is a game console.
`Through:
Does not adjust picture quality (changes resolution).
`Direct:
Does not adjust picture quality (does not change
resolution). The video coming from an analog input
and output by HDMI output(s) is processed in the
same way as “Through”.
With “Picture Mode”, you can change the following
settings to be suitable for the movie or game screen by one
operation; “Game Mode”, “Film Mode”, “Edge
Enhancement”, “Noise Reduction”, “Brightness”,
Contrast”, “Hue”, “Saturation” or “Color
Temperature”.
Game Mode
*2*3*4
`Off
`On
If video signal delay occurs during playback on a video
component (i.e., game console), select the corresponding
input source and set the “Game Mode” setting to “On”.
The delay will decrease but in return the picture quality will
become poor.
Space:
Enters a space character.
Shift
*1
:
Toggles between lower and upper case characters.
(Left)/ (Right):
Moves the cursor left or right in the Name input
area.
Back Space
*2
:
Moves the cursor backward and deletes one
character.
OK:
Confirms your entry.
Tip
*1
This can also be performed by using +10 on the remote
controller.
*2
Press CLR on the remote controller to delete all the
characters you have input.