Filter
Top Products
31
Using remote controller
Controlling an Onkyo DVD player
Make sure that you point the remote controller toward the remote
control sensor of the DVD player. If it does not operate properly,
change the code to 02 (refer to page 32).
When the DVD player is connected with z connecter of the
HT-R490, change the code to 01 and point the remote controller
toward the HT-R490 (refer to page 32).
1. Press the DVD MODE button.
2. Press the STANDBY/ON button to turn on the
Onkyo DVD player.
3. Press the desired operation button.
DVD operation buttons
s :Starts playback of DVD.
e :Stops playback.
f :Searches the disc in the forward direction.
d :Searches the disc in the reverse direction.
2/8 :Lets playback pause temporarily or advances the disc
frame by frame.
w :Starts playback from the beginning of the next
chapter/track.
q :Starts playback from the beginning of the current
chapter/track.
DISC : This button is valid when the DVD changer is used
and selects the disc to be played.
OSD operation buttons
TOP MENU :Displays the top menu of each DVD disc.
MENU : Displays a menu recorded in the DVD disc.
RETURN : Returns to the previous menu.
SETUP : Displays the setup menu.
5/∞/2/3 :Selects an item in a menu.
ENTER : Enters the selection in memory.
INPUT SELECTOR
SLEEP DIMMER DISPLAY
CD TAPE TUNER
D V D VIDEO 1 VIDEO 2
SUR MODE
SW MODE AUDIO SEL
TUNER
PRESET
STANDBY/ ON
DISC
MUTING
VOLUME
TOP MENU
MENU
CH SEL
RETURN
SETUP
TEST TONE
LEVEL
ENTER
DVD MODE
STANDBY/ON
R
C
-
4
4
6
M
R
E
M
O
T
E
C
O
N
T
R
O
L
L
E
R
MODE
TV CABLE SATELLITE
VCR
STANDBY/ ON
DVD CD TAPE
CH
TV/VCR
CH TV VOL
TV VOL
DVD operation
buttons
OSD operation
buttons