Filter
Top Products
7
Front & Rear Panels—Continued
A Grounding terminal
This terminal is for connecting a turntable’s ground
wire.
B PHONO (MM) input
This analog audio input is for connecting a turntable
with a moving-magnet cartridge.
C SPEAKERS A
These terminal posts are for connecting speaker set
A.
D SPEAKERS B
These terminal posts are for connecting speaker set
B.
E AC INLET
This connector is for connecting the supplied power
cord (see page 5).
F CD input
This analog audio input is for connecting a CD
player’s analog audio output.
G TUNER input
This analog audio input is for connecting a tuner’s
analog audio output.
H TAPE IN/OUT
This analog audio input and output are for connect-
ing a cassette deck with an analog audio input and
output.
I MD IN/OUT
This analog audio input and output are for connect-
ing an MD recorder with an analog audio input and
output.
J HDD IN
This analog audio input is for connecting a compo-
nent’s analog audio output (RI Dock, etc.).
K LINE input
This analog audio input is for connecting a compo-
nent’s analog audio output (TV, etc.).
L MAIN IN (A-9755 only)
This analog audio input is for connecting a separate
preamp when you want to use the A-9755 as a
power amplifier.
Caution:
Do not connect a component that does not have an
output volume control, such as a CD player,
because the sound will be output at maximum vol-
ume and may damage the A-9755 and your speak-
ers.
M REMOTE CONTROL jacks
These (Remote Interactive) jacks can be con-
nected to the jacks on your other Onkyo audio
components. The A-9755/A-9555’s remote control-
ler can then be used to control all of your compo-
nents. To use , you must make an analog audio
connection between the A-9755/A-9555 and each
component.
Rear Panel
1 2 4 53
87 90ABC6
This illustration is for A-9755.
(A-9755 only)
See pages 10–13 for connection information.