Filter
Top Products
17
Enjoying Audio Sources—Continued
You can use the A-9755 as power amplifier with a sepa-
rate preamp. See page 13 for connection information.
Notes:
• You can record on a recorder that’s connected to the
MD OUT or TAPE OUT L/R jacks.
• The tone controls have no effect on the signal being
recorded.
• When using the A-9755 as a power amplifier (MAIN
IN function), recording is not possible.
Using the MAIN IN Function (A-9755
only)
1
Press the [POWER AMP DIRECT
(MAIN IN)] button for 3 seconds
until the MAIN IN indicator lights up.
The MAIN IN function comes on and
the MAIN IN indicator lights up.
While the MAIN IN function is on,
only audio from components con-
nected to the preamp can be output.
To turn the MAIN IN function off,
press the [POWER AMP DIRECT
(MAIN IN)] button for 3 seconds until
the MAIN IN indicator goes off.
Notes:
• Do not connect a component that
does not have an output volume con-
trol to the MAIN IN jacks and use the
MAIN IN function, because the
sound will be output at maximum
volume and may damage the A-9755
and your speakers.
• While the MAIN IN function is on,
the A-9755’s Volume control has no
effect. Before you turn off the
MAIN IN function, make sure that
the Volume control is not turned up
high, to prevent any loud surprises.
• While the MAIN IN function is on,
the following A-9755 functions are
disabled:
- Volume control
- Input selector
- Remote control operation
- function
- LOUDNESS control
- Recording
- Muting
Operate the connected preamp for
some of these functions including
controlling volume, selecting input,
and muting. The [STANDBY] and
[ON] buttons on the remote control-
ler will work even when the MAIN
IN function is on.
POWER AMP DIRECT (MAIN IN)
Recording
1
Use the input selector to select
the component that you want to
record from.
2
Prepare the recorder:
• Set the recorder so that it’s ready for
recording.
• If necessary, adjust the recording
level on the recorder.
• See the recorder’s manual for more
information.
3
Start playback on the component
selected in step 1.
Note:
If you select another input source dur-
ing recording, the newly selected input
source will be recorded.
Unless you have the full consent of the
copyright holder, copyright laws prohibit
using your recordings for anything other
than personal enjoyment!
Input selector