Filter
Top Products
2-1
2
Daily Operation
2.1 Recording
Switching Power ON/OFF
The power switch is located at the lower right-hand corner of the front face behind the
door. The switch is a push-button type. Press the switch to turn the recorder ON and
press again to turn it OFF.
After the power turns ON, the recorder executes a self-diagnostic check for several
seconds before starting measurement and recording.
ON
OFF
Power Switch
Note
• The warm-up time is approximately 30 minutes; however, after the initial start-up, the recorder
might need more time.
• If the input wiring is connected parallel with other equipment, do not turn the power switch ON/
OFF to prevent fluctuations in measuring values.
Starting/Stopping Recording
Press the RCD key to start or stop the recording.
Feeding Chart Paper
The chart paper is fed by pressing the FEED key as long as the key is pressed.
See also Section 2.4,
Loading Chart Paper
.
Chapter 2 Daily Operation