Omage IPRD8 Speaker User Manual


 
7
IPRD SERIES OWNER’S MANUAL
IP SERIES
The IPRD6.5, IPRD6.5ST and the IPRD8 speakers use the same installation directions as all OMAGE IN-PERFORMA
speakers. Please pay close attention to the wiring of the speakers. The single in-ceiling series produces the left and right
audio signal from one speaker. The crosover on the back of the speaker, shown below features two pairs of push-to-
connect gold terminals.
Attach the wire from your amplifier to the terminals on the back of the speaker. Double check the polarity of the speaker
wires, amplifier +to speaker+and speaker- proper polarity is critcal. The left and right channels are the same
regardless of which side you connect the speaker wires.
ADJUSTING YOUR SPEAKERS
Note: Do not apply pressure to the tweeter dome. The pivoting tweeter can direct sound toward or away from the listening
area. To pivot the tweeter, apply light pressure to the plastic ring around the outside edge of the tweeter.
Here are some suggestions:
Orient the pivoting tweeter toward the listening area if the speakers are widely separated and the music fails to
blend into a central image when the system is operated in stereo.
If you are using the speakers as channels in a home theater you can point the pivoting tweeter towards a wall or
window to create a diffuse surround affect.
If you have any questions about how the pivoting tweeter should be adjusted, consult your authorized OMAGE
dealer.