Nuvo NV-E6GMS Speaker System User Manual


 
10
M3 Audio Server and T2SIR Dual Sirius Ready Tuners
At initial startup, the front panel display will display a
prompt screen Status, all outputs. Below this header are
three lines of text representing each of the three audio
outputs labeled A, B, and C. Output A will be highlighted and
it will display OUTPUT A: PRESS OK TO SELECT NUVONET
SOURCE. When OK is selected, the top line of the display will
read Address, Output A, below this, STANDALONE will be
highlighted and the other choices will be SOURCE 1, SOURCE
2. . . and as you scroll using the down arrow, SOURCE 3,
SOURCE 4, SOURCE 5, and SOURCE 6 will appear. Highlight
the appropriate choice and press OK to select. This will set
the first channel music output. You will then be prompted to
repeat these steps for the remaining two channels.
VII. Connecting the IR Emitters for Third-Party Source
Components (Fig. 6)
IR commands for the source equipment are transferred from
the Essentia amplifier to the source equipment using the
mini IR mouse emitters. Six of these are supplied with your
Essentia System. The emitter is plugged into the
corresponding source IR output on the Essentia and then
placed over the IR receiver window on the source
component. The IR outputs are individually routed to
sources 1-6.
Fig. 6
NuVoDock for iPod
Both the Wired and Wireless NuVoDocks for iPod use a
simple rotary switch to set the appropriate source input. Up
to two Wireless NuVoDocks and six Wired NuVoDocks could
be used as individual sources through NuVoNet. The Wired
and Wireless NuVoDocks consist of a dock for iPod playback
and recharging as well as a receiver component designed to
communicate with NuVoNet. Prior to plugging the receiver
into the Essentia Allport, set the Source rotary switch to the
desired source number input. Once set, theEssentia Control
Pads will automatically display the iPod information when an
iPod is plugged into the NuVoDock. Each NuVoDock and
receiver must have a separate source number selected.
Note that although the NuVoDock system has a 16 position
rotary switch for source input, only positions 1 – 6 are used.
The two SUM outputs will flash any IR command that is sent
from any of the zones. This is most commonly used with an
IR blaster designed to flash IR commands to a variety of
components.
STATUS
NuVoNet
RS232
1
SUM
ALLPORT CONNECTION
IR OUTPUTS
2 3 4 5 6
LINK
MUTE
ALLPORT CONNECTION
dISC
COMPACT
NuVo T2G Tuner Direct Numeric Access (Fig. 7)
The NuVo T2G Tuners have the ability for direct IR access to
numeric station tuning. This can be done through the T2G
remote control or using a third party remote control that has
been taught the T2G IR codes. To allow this control, it is
necessary to link the Essentia SUM IR output to the Direct IR
input on the T2G using a stereo 3.5mm (1/8 ) mono patch
cable. Once the connection is made, the T2G will respond to
the numeric IR commands issued through the Essentia
Control Pad IR receivers.
Fig. 7
T2G Tuner IR Input
Essentia IR Ouput
Model NV-T2DF
Dual XM Tuner
NuVo Techonlogies LLC
Cincinnati Ohio USA
www.nuvotechnologies.com
SYSTEM
IR PASS-THRU
IR INPUT
NuVoNet
OUTIN
RS232
STATUS
NuVoNet
RS232
1
SUM
ALLPORT CONNECTION
IR OUTPUTS
2 3 4 5 6
LINK
MUTE
ALLPORT CONNECTION