Filter
Top Products
I
NTELLIGENT
P
OWER
C
ONTROLLER
15
the display allow you to adjust the delay from 0 to 99 seconds.
3. Press the
SELECT button to lock in your programming and
move to the next outlet. Repeat steps 1-3 for outlets 2
through 6 and C1, C2. Pressing the
SELECT button after you
have programmed C2 enables you to program the "off" time
delays. If you elect not to program one or more of the outlets,
you will still need to press
SELECT until you have gone past C2
to program the "off" times. The IPC-6 will now light the
OFF
and "Outlet 1" LED's.
4. Adjust the "off" time delay. There is no need to select a
trigger. After you have programmed your "off" time for
Outlet 1, use the
SELECT button to step through outlets 2-6
and C1, C2. Adjust the "off" time delay of each.
5. Pressing the
SELECT button after you have programmed C2
will cycle you back to programming the "on" time delays.
6. Press the
PROGRAM button and release it. All the front panel
LED's will light for 2 seconds. You have completed program-
ming your IPC-6.
Test
Test that you have programmed your IPC-6 properly by turn-
ing on the components plugged into the "A" trigger outlet.
The IPC-6 should now activate your other components
according to the sequence you have programmed. Repeat
this test with the component plugged into the "B" sensing
outlet.
If the IPC-6 fails to initiate the sequence you have pro-
I
NTELLIGENT
P
OWER
C
ONTROLLER
16
grammed, return to the programming section of this manual
and verify that the IPC-6 has been programmed correctly or
simply reprogram the IPC-6.
Errors - The display reads E1
The IPC-6 detected a contradictory reading. Check your con-
nections to the sensing 120 volt AC outlets. Perhaps “A” and
“B” have been reversed or are actually plugged into another
outlet.
Press the
PROGRAM button to turn off the display of E1, then
begin again at step one. Make sure you are "on" and "off"
when the directions say you should be.
Cancel Programming
At any time, you may stop programming by simply pressing
and holding the
PROGRAM button for one second.