Filter
Top Products
OPERATING INSTRUCTIONS
UHF-16 Receiver
7
2. Installing Antennas
Install antennas by connecting the
two antennas included with your
system, or optional remote
antennas, to the two each BNC
RF TWIST-ON CONNECTORS
(5) located on the back of your
UHF-16 receiver. If using either
single or side-by-side front panel antenna mounting, as described above, attach either the supplied or
optional remote antennas to the FRONT PANEL BNC CONNECTORS (6e) as shown. For best
performance, point the antenna tips away from each other at a 90° angle (45° from vertical axis).
3. Powering the Receiver
Plug the AC/DC ADAPTOR (1) provided in the 12 VDC INPUT JACK (2) on the back of the receiver. Then
plug the adapter into an AC outlet.
(Note: Any center positive 12V DC source with 500 mA capability can
also be used.)
Turn the VOLUME CONTROL (7) counterclockwise to minimum and press the POWER SWITCH (8) ON.
The POWER ON LED (9) will now light, and the receiver is operational.
The LCD DISPLAY (11) should also be lit. The AUDIO LEVEL (11b) and RF LEVEL (11a) meter icons will
not display until your transmitter is turned on, your frequency selection common to both the transmitter and
receiver is made, and the system is operational. The AUDIO LEVEL METER (11b) will display when you
then speak into the attached microphone or play the connected instrument.
UHF-16 BACK PANEL
UHF-16 FRONT PANEL
(1)
(2)(3)(4)(5)
(5)
(7)
(8) (9) (10) (11) (12) (13)