Filter
Top Products
OPERATING INSTRUCTIONS
UB-16 Bodypack Transmitter
12
1. Powering the Transmitter
Slide open the BATTERY COMPARTMENT (21) and insert 2 fresh AA ALKALINE BATTERIES (22),
observing the correct polarity. Two fresh
alkaline batteries can last up to 12
hours in use, but in order to ensure
optimum performance, it is
recommended that the battery be
replaced after 8-10 hours of use.
2. Selecting Input for
Operation
The UB-16 is equipped with an INPUT
SELECTOR SWITCH (23) in the battery
compartment for selecting the type of
audio input you will be supplying to the
transmitter. Select from the choice of
three positions: GT (for guitar, bass,
etc.) / HM (for headworn mic)/ LT (for
lavalier mic).
3. Connecting the Audio Source
The UB-16 is provided with a 3.5 mm LOCKING
JACK (27) for connecting the audio input
selected. Connect either the INSTRUMENT (31)
cord or the HEADWORN MIC (32) or LAVALIER
MIC (33) cord as desired, according to the input
selected.
To secure the connection, turn the slip ring on
the plug clockwise to thread it on the jack. To
unplug, reverse the process. Slip the transmitter
into a pocket or CLIP (34) it on to your clothes or
instrument strap (if using the UB-16 as an
instrument transmitter).
(Note: Use only the input audio source as per the
input selected with the AUDIO INPUT
SELECTOR SWITCH or the audio will not be
optimal– a muddy or distorted sound may result.)
4. Turning on the Transmitter
Turn on the UB-16 by sliding the OFF/STANDBY/ON SWITCH (28) to the STANDBY position (transmitter
on, audio muted) or the ON position (transmitter and audio both on). The BATTERY INDICATOR LED
(30) will give a single quick flash, indicating usable battery strength. In the case of dead or low batteries,
the LED either will not go on at all or will stay on continuously, indicating that the batteries should be
replaced with fresh ones. If the Tone Squelch™ is activated on both transmitter and receiver, the LOW TX
BATTERY ICON (11c) on the receiver’s LCD DISPLAY (11) will switch from the battery OK to the LOW
battery mode. See CHANNEL DISPLAY AND UP/DOWN BUTTON OPERATION, page 15 and UHF-16
OPERATING INSTRUCTIONS, page 8.
Inside the cover, the channel number on the CHANNEL LED DISPLAY (24) will extinguish in 10 seconds.
The activity indicator “ ’’ or “ ’’ LED will remain on in the DISPLAY. See CHANNEL DISPLAY AND
UP/DOWN BUTTON OPERATION, page 15.
(21)
(22)
Inside Battery Compartment
(23)
(24)
(25)
(26)
Top View
(27)
(28)
(29)
(30)
(34)