Filter
Top Products
35
USING THE HTR 2 REMOTE CONTROL
FACTORY RESET
The HTR 2 can be reset to its factory state, deleting all learned commands, copied and punched-trhough
keys, macros, and other setup information, reverting all keys to their pre-programmed library commands.
To perform a factory reset simultaneously press-and-hold for 10 seconds the HTR 2’s [ON] and [RTN] keys;
the Learn LED will start to flash green. Release [ON] and [RTN] before the second flash is complete; the
Learn LED will turn red, indicate the remote has been reset.
NOTE
You must release [ON] and [RTN] before the second flash goes out, otherwise the unit will not reset;
should this occur, repeat the full procedure.
DELETE MODE
The HTR 2 can store learned, copied, and “default library” commands on any single key. (The default
library commands are the pre-programmed NAD codes, such as the native NAD receiver commands on
the [AMP] “page.”) You can delete commands by layers back “down” to the default library command on
any key, removing learned commands, punched-through functions, and copied keys.
NOTE
The default library commands cannot be deleted, so you need not worry that using Delete Mode
might cause irreparable changes.
To enter Delete Mode, simultaneously press-and-hold for 3 seconds both the desired key’s Device Selector
key and the [RTN] key, until the Learn LED turns green. Press the function key whose command you wish
to delete; the Learn LED flashes; the number of times indicates which type of function has become active-
see the table below. Press the active Device Selector key again to exit Delete Mode.
Flashes Command Type
1 Default Library Command
2 Copied Library Command
3 Learned Command
ENGLISH
FRANÇAISDEUTSCHESPAÑOLITALIANO
PORTUGUÊS
SVENSKA