Filter
Top Products
ENGLISH
FRANÇAISDEUTSCHESPAÑOLITALIANO
PORTUGUÊS
SVENSKA
27
USING THE S170i
ADJUSTING THE TONE CONTROLS
Press the [ Tone] key; "Treble" appears on the OSD and the front-panel readout. Use the remote's [Cursor
Left/Right] to boost or cut treble by 1 dB increments. Press [ Tone] again to adjust bass, similarly using the
[Cursor Left/Right] keys; "Bass" appears on the OSD and readout. Press [ Tone] again to exit the tone-
control function.
FRONT PANEL TONE BUTTON: Press to toggle between Bass, Treble, and TONE ON. The VOLUME knob
is used to adjust the Bass and Treble levels.
NOTE THAT:
• Bass/treble settings affect only the front channels (left, center, and right), and are active in all listening
modes
• Bass/treble settings imposed via the HTR 2 remote's [ Tone] will override those stored on the <Audio
setup> menu, but they are temporary: Cycling through the S170i's Standby mode (or recalling the
<Audio setup> menu), or recalling a Preset, will override them and revert to the settings selected by
<Audio setup> or the recalled Preset.
USING PRESETS
From the HTR 2 select [AV Preset]; then press the [ 1] through [ 5] numerical key to select the desired
Preset.
NOTE THAT:
• The selected Preset remains in force until you select a different Preset, or cycle the S170i through its
Standby mode.
•A Preset applies regardless of what source is selected, or what listening mode is in operation.
• Cycling the S170i through its Standby mode cancels any selected Preset, reverting both tone and all
level settings to those set on the HTR 2 remote’s LEVELS or MODE/MULTI.S screens, or the S170i
preamp’s <Audio setup> OSD menu (above).
•A Preset’s channel levels are added to the setup levels established on the S170i preamp’s <Levels
setup> OSD menu; a Preset’s tone-control settings override those established on the <Audio setup>
OSD menu (or the MODE/MULTI.S remote page) entirely.