Filter
Top Products
ENGLISH
FRANÇAISDEUTSCHESPAÑOLITALIANO
PORTUGUÊS
SVENSKA
13
ABOUT THE ON-SCREEN DISPLAYS (OSD) AND FRONT-PANEL READOUT
The S170i preamplifier employs a simple, self-explanatory system of on-screen display “menus” that will
appear on the system’s video monitor/TV, useful both during setup and in day-to-day operation. While the
OSDs are always helpful, it is also perfectly possible to operate (or even set up) the S170i without them,
because the same basic data is always shown, though sometimes in shortened format, on the preamp’s
own front-panel readout.
DISPLAYING THE MENUS
Once a video monitor (TV) is connected to the Monitor Output of the S170i, pressing the left or right
cursor keys of the HTR 2 remote will access the S170i’s OSD (On Screen Display) where all system
setup parameters can be easily adjusted using the up and down and [ENTER] keys.
• If the OSD does not appear, check your Monitor Out connections, and/or the settings of the <Video
format> and <OSD display> items of the <Display setup> menu (see below) using the S170i’s front-
panel readout.
NAVIGATING THE OSD AND MAKING CHANGES
Use the remote’s [Cursor ] keys to move up or down among any OSD menu’s list of items; use the
[Cursor ] keys to change the value (setting) of any item; use remote’s [Enter] key to select an OSD
menu item. Selecting <Exit> from the Menu Page saves any changes you have made and departs that
menu for the next “higher” level (or, from the Main Menu, turns the OSD off).