NAD S170 Stereo Amplifier User Manual


 
GB
9
QUICKSTART
In case you simply cannot wait to experience the performance of your new S170 preamplifier, we provide
the following "Quickstart" instructions to get you underway. They assume that the DVD/CD player is
connected to the VIDEO1 input and that the appropriate audio and video connections have been made.
PLAY A DVD MOVIE (OR MUSIC CD)
From the S70 remote's PREAMP menu, select [@ Source]; then press the [Source up] key until VIDEO 1
appears on the front-panel readout (and on-screen display, if this is enabled; see "Display setup," below).
Use the S70 remote's [VOLUME up/down] keys to adjust the volume.
Start playback of the DVD/CD player. From the S70 remote's PREAMP menu, select [MODE/MULTI.S]; then
press the [Mode •] key; the [Cursor up/down] keys will now cycle through all of the S170 listening modes
that are available for the current input signal type (see "About the S170's Listening Modes," below).
Depending on the signals format and connections you have made, some listening modes may not yet be
available (see "Configuring the S170”, below). You may need to use the DVD player's on-screen menu
system to select a surround-capable signal format.
Enjoy the movie or music, but be sure to set aside time to read this manual thoroughly and to set up,
calibrate, and configure your S170 carefully.