Filter
Top Products
GB
25
USING THE S170
ADJUSTING THE TONE CONTROLS
From the S70 remote's PREAMP menu, select [MODE/MULTI.S]; then press the [•Tone] key; "Treble"
appears on the OSD and the front-panel readout. Use the remote's [Cursor up/down] to boost or cut treble
by 1 dB increments. Press [•Tone] again to adjust bass, similarly using the [Cursor up/down] keys; "Bass"
appears on the OSD and readout. Press [•Tone] again to exit the tone-control function. See also "Audio
Setup," and "Configuring Presets," above.
NOTE THAT:
• Bass/treble settings affect only the front channels (left, center, and right), and are active in all
listening modes
• Bass/treble settings imposed via the S70 remote's [•Tone] will override those stored on the <Audio
setup> menu, but they are temporary: Cycling through the S170's Standby mode (or recalling the
<Audio setup> menu), or recalling a Preset, will override them and revert to the settings selected by
<Audio setup> or the recalled Preset.
USING PRESETS
From the S70 remote's PREAMP menu, select [PRESET 1-5]; then press the [•Preset1] through [•Preset5]
key to engage the desired Preset. Keying [Exit] returns to the PREAMP menu but leaves the last-selected
Preset in force.
NOTE THAT:
• The selected Preset remains in force until you select a different Preset, or cycle the S170 through its
Standby mode.
•A Preset applies regardless of what source is selected, or what listening mode is in operation.
• Cycling the S170 through its Standby mode cancels any selected Preset, reverting both tone and all
level settings to those set on the S70 remote's LEVELS or MODE/MULTI.S screens, or the S170 preamp's
<Audio setup> OSD menu (above).
•A Preset's channel levels are added to the setup levels established on the S170 preamp's <Levels setup>
OSD menu; a Preset's tone-control settings override those established on the <Audio setup> OSD
menu (or the MODE/MULTI.S remote page) entirely.