Filter
Top Products
9
PLUG INTERFACE
CABLE INTO THE
INTERFACE
CONNECTOR ON
CD PLAYER
DMC1MM
SHOWN
PLUG LEFT AND RIGHT
AUDIO CABLES INTO
CD PLAYER AUDIO
JACKS
AUDIO
RIGHT
AUDIO
LEFT
Figure 25. dmc1MM iPod
®
Dock MP3 & CD Player
Interface and Audio Cable Connection
PLUG POWER CONNECTOR
FROM THE TRANSFORMER
INTO CD PLAYER'S POWER
CONNECTOR
DMC1MM
SHOWN
Figure 26. dmc1MM iPod
®
Dock MP3 & CD Player
Power Connection
CD PLAYER
INTERFACE CABLE
CD PLAYER
AUDIO CABLES
CD PLAYER
POWER CABLE
DMC1CD
SHOWN
AUDIO
LEFT
AUDIO
RIGHT
Figure 27. dmc1CD 6-Disc CD Player Connections
CD PLAYER SLIDES
INTO BOTTOM OF WALL
HOUSING
MASTER MOUNTED IN
TOP OF WALL HOUSING
BE SURE THAT THE AREA BEHIND
CD PLAYER IS CLEAR OF CABLES
SECURE CD PLAYER WITH
TWO LONG SCREWS, THEN
SNAP ON THE COVER
Figure 28. CD Player into Wall Housing
Mounting the Master Station with the Optional CD
Player (continued)
9. Insert the CD Player interface cable into the INTERFACE
connector on the CD Player (see Figure 25 or 27).
10. Insert the CD audio cable’s BLACK RCA plug into the AUDIO LEFT
jack on the CD Player, then insert the cable’s RED RCA plug into
the AUDIO RIGHT jack on the CD Player (see Figure 25 or 27).
11. Plug the connector from the TE2D power transformer in the wall
housing to the CD Player’s POWER connector (see Figure 26 or 27).
12. Be sure that the area where the CD Player will slide into
the wall housing is free of cables and connectors that
might be in the way when the player is inserted.
13. Attach the CD Player to the wall housing using the two long
screws provided as shown in Figure 28. DO NOT OVERTIGHTEN
THE SCREWS THE FRAME MIGHT DISTORT OR CRACK!
14. If installing the dmc1CD 6-disc player, connect the EJECT
button cable to the very small two-pin connector located
under the lower right edge of the CD mechanism frame.
15. Install the CD Player faceplate by pressing it onto the player.
POWERING UP THE SYSTEM
After all connections have been made and the unit(s) are
installed into the wall housing, follow these steps to power
up the dmc1 system.
1. Turn the circuit breaker controlling the power
to the wall housing transformer(s) ON.
2. Check all functions of the system. Refer to the Owner’s Manual
supplied with the dmc1 Master Station for operation details. If
any diffi culties are encountered, recheck all connections.