Filter
Top Products
8
Mounting in a Master Station Only Installation
When the dmc1 Master Station is used without the optional
CD Player, the dmc1 mounts inside the dmc1H wall housing.
Follow these steps for mounting the Master Station.
1. Verify that the circuit breaker controlling the power
to the wall housing transformer is OFF.
2. Plug the connector on the dmc1 Master Station’s wiring
harness into the connector on the TE5D power transformer.
3. Secure the dmc1 Master Station to the wall housing
using the two long screws provided (see Figure 21).
4. Install the speaker grille onto the right side of the dmc1
Master Station. BE CAREFUL NOT TO PRESS IN THE
CENTER OF THE GRILLE! Only press around the edges.
Mounting the Master Station with the Optional iPlay
Dock and CD Player
When the optional CD Player is included, the dmc1 Master
Station and the dmc1CD 6-disc CD Player or dmc1MM
iPlay
™
Dock for iPod
®
- MP3 & CD Player mounts inside the
dmc1HC combination wall housing.
Follow these steps for mounting the Master Station and CD
Player:
1. Verify that the circuit breaker controlling the power
to the wall housing transformers is OFF.
2. Insert one end of the CD Player interface cable into the CD interface
connector on the dmc1 Master Station. This connector is located
in the center of the dmc1 Master Station’s middle circuit board
approximately behind the two TUNE buttons (see Figure 22).
3. Insert the CD audio cable’s BLACK RCA plug into the CD L jack
on the dmc1 Master Station, then insert the cable’s RED RCA plug
into the CD R jack on the dmc1 Master Station (see Figure 23).
4. Plug the connector on the dmc1 Master Station’s wiring
harness into the connector on the TE5D power transformer.
5. Position the dmc1F combination mounting frame over the
dmc1HC wall housing with the larger opening toward the top.
6. Be sure to route the CD interface and audio cables in
through the top opening of the dmc1F frame then down
and out the lower opening in the dmc1F frame.
7. Secure the dmc1 Master Station to the wall housing using the two
long screws provided (see Figure 24). DO NOT OVERTIGHTEN
THE SCREWS THE FRAME MIGHT DISTORT OR CRACK!
8. Install the speaker grille onto the right side of the dmc1
Master Station. BE CAREFUL NOT TO PRESS IN THE
CENTER OF THE GRILLE! Only press around the edges.
BE SURE THE AREA
IN THE WALL HOUSING
BEHIND THE MASTER
IS CLEAR OF CABLES
ATTACH THE MASTER
TO THE WALL HOUSING
WITH TWO SCREWS
PLUG CD INTERFACE
CABLE INTO MASTER
THE CONNECTOR LOCATION IS:
BOTTOM OF MASTER,
MIDDLE CIRCUIT BOARD,
BEHIND THE TUNE BUTTONS
LEFT
CD AUDIO
INPUT
RIGHT
CD AUDIO
INPUT
PLUG CD AUDIO CABLES
INTO LEFT & RIGHT
CD AUDIO INPUT JACKS
DMC1 MASTER MOUNTED
INTO DMC1HC WALL HOUSING
DMC1F COMBINATION
MOUNTING FRAME
CD PLAYER
INTERFACE CABLE
CD PLAYER
AUDIO CABLES
CD PLAYER
POWER CABLE
DMC1HC
WALL
HOUSING
Figure 21. Master Station Only in dmc1H Wall Housing
Figure 22. CD Player Interface Connection on Master Station
Figure 23. CD Input Jacks on Master Station
Figure 24. dmc1F Frame with Master Station, Ready for CD
Player