Filter
Top Products
Quick Start
For those of you who prefer to burn now and read later, we've included this Quick Start section to get you up and running.
Connect Cables:
Connect guitar into the Bright or Normal input jacks. If an extension cabinet is to be used, connect an un-shielded speaker cable to the
extension speaker cabinet output (located on the rear panel of the Millennium) and run into the desired extension speaker cabinet (such as the
Johnson Amplification 2-12 HB) with a 4ohm minimum requirement per channel .
Connect J-3 Multi-Function Footswitch:
Connect the included J-3 Footswitch to the J-3 insert on the rear panel of the Millennium. The three footswitches can be programmed to
perform several functions. From the factory, the footswitches will A-B Channel Switch and change presets Up and Down.
Connect Johnson Amplification J-12 Foot Controller (if applicable)
Connect the output of the optional Johnson Amplification J-12 to the Foot Controller jack found on the rear of the Millennium. Make sure that
connection is made before applying power to the Millennium.
WARNING: DO NOT CONNECT ANYTHING BUT THE OPTIONAL JOHNSON AMPLIFICATION J-12 FOOT CONTROLLER TO THE FOOT
CONTROLLER JACK ON THE REAR PANEL! DOING SO MAY DAMAGE THE DEVICE.
MIDI control of the Millennium can be done by connecting MIDI controller devices to the MIDI In jack on the rear panel.
Apply Power:
Note: When applying power to the Millennium, it is recommended that the <Input> and <Master Volume> be turned down prior to
powering up the unit.
Adjust Input and Output:
Use the <Input> level knob on the front panel to adjust the Input level, so that the loudest guitar signal occasionally lights the clip LED
indicator. Now adjust the <Master Volume> level knob on the front panel of the Millennium to the desired output level .
Select Preset:
Begin playing your guitar, and choose any preset using the <Preset/Effect> wheel. User Presets 1-100 are duplicates of the Factory Presets.
They are user-programmable. You can modify and store them as you want. Factory Presets 1-100 are not user-programmable and cannot be
overwritten.
Johnson Millennium
User Guide
II