Filter
Top Products
8. Use the <2> knob to adjust the attack time of the Dyn.
9. Use the <3> knob to adjust the hold time of the Dyn.
10. Use the <4> knob to adjust the release time of the Dyn.
Morphing Pedal Assignments
The Johnson Amplifier modules and the effect configurations within the Millennium have special morphing capabilities that allow you to
morph between one amplifier type to another in selected amplifier models. This feature is also available in certain effect configurations so you
can pan between effects. This will allow you to either morph from a distorted Tube amplifier type, to a clean Solid State amplifier type or
morph between digital effects. Morphing can be done by linking an expression pedal to the Morph pedal parameter.
Amplifier Morphing
To assign the morphing pedal to morph between amplifier types use the following procedure.
1. Amplifier type morphing must be done using a Johnson Amplifier model. So, from Preset mode, press the <Johnson> button until the
signal path in the display shows an amplifier model that uses dual amplifier modules and is displayed something like this:
2. Using either the <Channel> button or the <4> knob, press (or turn) until both of the channel (A&B) LEDs light and the display
appears like this:
3. At this point, you want to assign the Morphing pedal by pressing the <Config> button and the display will appear something like this:
Config: Series 2,2
2
FACTORY USER
%kHz
msdB
1
1
CHANGEDLINK
CHANGEDLINK CHANGEDLINK
PAGE
1
OF
2
WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
EQDIST
Fender/Soldano Chan
2
FACTORY USER
%kHz
msdB
CHANGEDLINK
J01
2
CHANGEDLINK
%kHz
msdB
CHANGEDLINK
A-b
4
CHANGEDLINK
PAGE
1
OF
5
WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
EQDIST
Fender/Soldano Chan
2
FACTORY USER
%kHz
msdB
CHANGEDLINK
J01
2
CHANGEDLINK
%kHz
msdB
CHANGEDLINK
b
4
CHANGEDLINK
PAGE
1
OF
5
WAH TUBE EQ
L/R OUTS
L/R OUTS
#
b
GATE
BANK
EQDIST
Johnson Millennium
User Guide
Section - 5 Advanced Topics
59