Filter
Top Products
38
TROUBLESHOOTING
Troubleshooting
Display on front panel not lit
Check the following:
•
There is AC power connected to the socket on the back of the DSP
loudspeaker.
•
The power switch on the back panel of the DSP loudspeaker is turned
on.
If the display will still not illuminate, check any fuses in your power supply
and the fuse in the inlet of the DSP loudspeaker. If these are all intact,
contact your dealer.
Remote not working
Check the following:
•
The battery in the Meridian System Remote.
•
See if the DSP loudspeaker has been set up as not controller in the
Meridian Configuration program; see Changing the setup options, page
35. Note: This may be deliberate by your dealer.
Unit goes silent when played hard and displays ‘Hot‘
•
The DSP loudspeakers have a temperature sensing system on board,
which prevents overheating of the electronics. The sound will continue
when the speaker has cooled.
There is radio interference
The DSP loudspeaker is a digital audio and computing device which has
been designed to very high standards of electromagnetic compatibility.
If this equipment does cause or suffer from interference to/from radio or
television reception then the following measures should be tried:
•
Reorient the receiving aerial (or antenna) or route the antenna cable of
the receiver as far as possible from the DSP loudspeaker and its cabling.
•
Ensure that the receiver uses well-screened antenna cable.
•
Relocate the receiver with respect to the DSP loudspeaker.
•
Connect the receiver and this product to different AC outlets.
•
If the problem persists contact your dealer.