31
CONFIGURING THE
DSP LOUDSPEAKERS
To specify the speaker position
• Press A or V to specify the speaker position.
The options are shown in the following table:
Display Position
L. Left.
R. Right.
C. Centre (Type 6 only).
S.L. Left surround (Type 6 only).
S.R. Right surround (Type 6 only).
To choose master or slave
You should select one loudspeaker to be the master; this will normally be
the centre channel. For more information see Setting up the DSP
loudspeakers, page 13.
The other DSP loudspeakers should be configured as slaves as follows.
• Press the green > (Play) key on the remote.
The display shows, for example:
L. Slv.
When you have configured the loudspeaker:
• Switch off the DSP loudspeaker, using the power switch on the back,
and then switch on again to restore normal operation.