Filter
Top Products
11
How to use the Remote Control
How to use the Remote Control
The supplied Remote Control is capable of directly con-
trolling the functions of contemporary McIntosh Source
Components connected to the MA7000 via the Data Ports.
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Mute
Press the MUTE Push-button to mute the audio in all
outputs except the REC OUTPUT. The MUTE LED above
the push-button will flash on and off to indicate that Mute
is active. To un-mute the audio, press the MUTE Push-but
-
ton again.
Mono
Press the MONO Push-button to switch from Stereo to
Mono for Monophonic listening.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre
-
sets, tracks on discs or selections on a Music Server.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc
Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel Up
or
Down Push-button to move from station to station. Press
and hold a Channel Up or Down Push-button to move
continuously from station to station. Press +10 Push-button
to start the automatic brief audition of each of the pre-
sets stored in the tuner memory. Press +10 Push-button a
second time to stop on a station preset and exit the review
process.
Volume
Press the Up
or Down VOLUME Push-button to raise
or lower the listening volume level.
Note: The Record Signals present at REC OUTPUTS are not
affected by volume changes.
Pause
Press the Pause Pushbutton to perform various functions
on a variety of McIntosh Components. It will also pause
the playing of a disc or tape player. The Pause Push-but-
ton will also allow for quick exiting from the active menu
when in the setup mode. The Pause Push-button is also
used as an Enter Push-button with some McIntosh compo-
nents
Acc On/Off
Press ACC ON to turn the power ON or ACC OFF switch
-
es AC Power ON or OFF to certain McIntosh Components
when connected via the Data Port and any McIntosh Com-
ponents connected to the ACC Power Control Jack.