Filter
Top Products
Figure 7. Installing a toggle bolt wall anchor. Figure 8–9. Attach the stand to the wall using 4 screws. Install the Stage.
8 Install TOGGLER
®
SNAPTOGGLE
®
toggle bolts at all
locations with a
1
/2-inch hole. To do this:
A) Hold the toggle bolt metal channel flat alongside the
plastic straps. Slide the metal channel through the
1
/2-
inch hole.
B) Hold the ends of the straps between thumb and fore-
finger and even them out. Pull the entire toggle bolt
toward you until the channel rests flush behind the
wall. Slide the plastic cap along the straps with the
other hand until the flange of the cap is flush with the
wall.
C) Place a thumb between the straps at the wall. Push
the thumb side to side, snapping off the straps level
with the flange.
U.S. Patent No. 6,161,999 and foreign counterparts thereof and of U.S. Patent No.
4,650,368. TOGGLER and its typeface and SNAPTOGGLE are worldwide registered trade-
marks of Mechanical Plastics Corp. For further technical information on these anchors, visit
www.toggler.com/products_hwh.html.
9 Hold the bracket at the mounting location.
Install the 10-24 x 1.25-inch machine screws in any
locations where toggle bolt wall anchors were placed.
Install a lag bolt and washer at any location where a
stud was found.
10 With the help of an assistant, line up the Stage speaker
with the mounted bracket and attach it using the two
large knobs.
IMPORTANT! There should be four press fit
washers—two attached to the bracket and two
attached to the speaker cabinet. When correctly
installed these washers should be flush next to each
other between the bracket and speaker cabinet.
12 Installation
®