Filter
Top Products
4 Place the bracket against the wall at the desired location.
It is important that the entire area behind the bracket,
and 8.5 inches to the left and right of the bracket be
free from obstructions and completely flat.
IMPORTANT! To allow the Stage to fully rotate
up or down, the following area must be free of
obstructions:
— 4 inches above of the bracket
— 6 inches below of the bracket
— 8.5 inches left and right of the bracket
5 Using a level, square the bracket and mark the 4 hole
locations.
6 Using a
1
/8" bit, drill four pilot holes.
IMPORTANT! If you drill into a stud during this
step, DO NOT widen the hole and DO NOT
install a toggle bolt wall anchor at this location—
you will eventually be installing a lag bolt dierctly
into the stud.
7 Use a
1
/2" drill bit, widen the pilot holes so toggle bolt
wall anchors can be installed.
Figure 5. Level the stand at the mounting location and mark the holes. Figure 6. Drill pilot holes at the marked locations. Widen any non-stud holes.
Installation 11