Filter
Top Products
Required hardware (included):
(5) wall anchors
(5) 1" Phillips head wood screws
Required tools (included):
6mm Allen tool
Required tools (not included):
Level
Electric drill and
1
/
4" and
1
/
8" drill bits
Phillips screwdriver
1 Hold the Fresco at the desired location. Examine the mount-
ing location to assure that the wall is free of obstructions.
Test the direction of rotation to assure that the speaker
can rotate toward your listening position. If the speaker
rotates away from your listening position, please refer to
'Which Direction Should It Rotate?' (page 5) and ‘Changing
the Direction of Rotation’ (page 7).
2 NOTE: These instructions describe the position of the
wall bracket with the Fresco mounted flush against a
wall (not rotated on its bracket).
NOTE: The center point of the wall-bracket is not the
same as the center of the Fresco. These directions
describe the location of the center of the wall-bracket,
which you will need to know in order to mount the
speaker at your desired location.
Determine where the center point of the wall bracket
should be marked (see figures 16 and 17).
Will the Fresco remain flat against the wall? If so, it can
be installed flush against an object such as a plasma
screen (see figure18).
Will the Fresco be rotated to point towards the listening
position? If so you need to leave space between the
nearest object to allow clearance for the speaker to pivot
(see figure 18). At least 6.75” (17.2cm) of clearance will
allow the Fresco to pivot within its full range of motion.
Less space is needed if the Fresco does not need to fully
rotate. As recommended ablove, before drilling any
holes, hold the Fresco at its desired location and rotate
it into place to assure you have adequate clearance.
Installing the Fresco