Mark Levinson N383 Stereo Amplifier User Manual


 
39
reset defaults If necessary, it is possible to reset all of the factory default settings for
the Nº383 Integrated Amplifier so as to start again with a “clean slate.”
Important Note: Resetting factory default settings causes any
customization of the unit to be lost, including custom
names, gain settings, offsets, etc.
To reset all settings of the Nº383 to the original factory settings,
1. Turn off power
You may either unplug it from the ac mains or use the front panel
power button; standby will not do. Wait for a few seconds for the
power supply to drain.,
2. Restore power while holding the setup button.
This process takes a few seconds, as a guard against accidental res-
toration of factory defaults.
3. Continue holding the setup button for about ten seconds
after the display reads “CLEAR SETUP?”
If you take your fingers off the buttons within these first ten sec-
onds or so, the operation will be cancelled, leaving your current
settings unchanged. If you persist in holding the setup button, the
display will show “FACTORY” “SETUP” “RESTORED” in sequence.