Filter
Top Products
30
Mark Levinson
Specifications
The correlation between published specifications and performance is unreliable.
Measurements of your amplifier yield excellent results by any standards. However,
only those specifications that apply to its actual operation are included here. Specifi-
cations are subject to change without notice.
Rated power output:
• 200 w/ch rms power @ 8Ω
• 400 w/ch rms power @ 4Ω
All above power ratings from 20 Hz–20 kHz at <0.5% THD
(assuming that the AC mains can deliver adequate current, without
its own voltage sagging)
Frequency response:
• within 0.2 dB from 20 Hz to 20 kHz
Signal to Noise ratio:
• better than –80 dB (ref. 2.83V)
Input impedance:
•100kΩ (balanced)
•50kΩ (unbalanced)
Voltage gain:
•26.8 dB
Input sensitivity:
• 2.83V output: 130 mV
• Full output: 1.82V
Power consumption:
•200W in on, 100W in standby, 10W in sleep
Mains voltage:
• determined by the needs of country for which the unit was
manufactured; cannot be reset by dealer or user
Overall dimensions:
See “Dimensions” on page 32.
Shipping weight:
• 130.5 lbs. (59.2 kg)
Net weight:
• 114.5 lbs. (51.9 kg)
Connector
complement:
• six custom binding posts
• three 3-pin XLR balanced input connectors
• three RCA input connectors
• two 1/8-inch mini-jacks for remote turn-on
• one RS-232 port on RJ-11
• two Mark Levinson communications ports on RJ-11, RJ-45
• one IEC-standard AC receptacle
Output impedance:
• less than 0.05Ω from 20–20,000 Hz