Filter
Top Products
19
Nº433 Power Amplifier
9. ~ac mains connector
Provides power to the Nº433 through the supplied power cord when
the supplied power cord is connected to the ~ac mains connector
and the electrical outlet. One IEC-standard AC mains receptacle
labeled ~ac mains is available.
Note
Before operating the Nº433, make sure the ~ac mains connector
label indicates the correct operating voltage for the current location.
Warning!
The Nº433 has been safety-tested and designed for operation
with a three-conductor power cord. Do not defeat the “third pin”
or “earth ground” of the power cord.
The Nº433 includes internal fuses as a final stage of protection. The
protection circuitry is designed so that only a catastrophic failure
will cause the fuses to blow. If this occurs, disconnect the power
cord from the Nº433 ~ac mains connector and the electrical outlet.
Then, contact an authorized Mark Levinson dealer for assistance.
Do not attempt to replace the fuse. There are no user-serviceable
parts within the Nº433.
Danger!
Potentially dangerous voltages and current capabilities exist
within the Nº433, even when power is disconnected from the ~ac
mains connector. DO NOT attempt to open the amplifier’s cabinet.
There are no user-serviceable parts inside the amplifier. Refer all
servicing to an authorized Mark Levinson dealer.