Filter
Top Products
66
ENGLISH
• If the copying fails in the middle of the
copying process, ERROR is displayed on
the remote control.
Check and perform steps 1 to 7 again.
11.
Once copying is completed, press the M button
on both remote controls.
SETUP
SETTING THE LIGHTING TIME
• The LCD lights up when the LIGHT buttons are
pressed. The LCD remains lit while the pressed
button is held down, and it goes off when the
button is released.
• The LCD continues to light up if another button
is pressed while it is lit or if pressed within two
seconds after the light goes off.
• The lighting time can be set in one-second units
from 0 to 60 seconds.
The LIGHT buttons have light-absorbing properties
that enable them to store light. If the buttons are no
longer illuminated in a dimly lit environment, bring the
buttons near a fl uorescent lamp or other light source
for a suffi cient amount of time. This should illuminate
the buttons again.
• The LIGHT buttons consist of a LIGHT1 and
LIGHT2 button, and they both perform the same
operation.
The factory default lighting time is set to 15
seconds.
This example shows how to set the lighting time to
20 seconds.
PAG E
12
2 3 4
LEARN
123
4
LEARN
123
4
1.
Hold down the M button for three seconds or
more.
The menu is displayed.
2.
Press the > button to display the second page
SETUP menu.
3.
Press the D1 (LIGHT) direct button .
The LIGHT is displayed on the LCD
4.
Press the 3 or 4 cursor button to set the
lighting time.
5.
Press the OK cursor button to enter the lighting
time.
6.
Once the setting is finished, press the M
button.
SETTING THE MACRO INTERVAL TIME
When a macro program is executed, control signals
are transmitted in sequence. This transmission
interval (interval time) can be set in 0.5-seconds units
from 0.5 to 5 seconds.
If the interval time is set in this Setup mode, the
interval times for all programmed macros are
changed. If necessary, use EDIT (see page 64) in the
macro program to change the individual transmission
times.
The factory default setting for the transmission
interval is 1 second.
This example shows how to set the interval time to
5 seconds.
PAG E
12
2 3 4
LEARN
123
4
LEARN
123
4
1.
Hold down the M button for three seconds or
more.
The menu is displayed.
2.
Press the > button to display the second page
SETUP menu.
3.
Press the D2 (I-TIME) direct button.
4.
Press the 3 or 4 cursor button to set the
interval time.
Holding down the cursor button fast-forwards the
time indicator.
5.
Press the OK cursor button to enter the interval
time.
6.
Once the setting is finished, press the M
button.
ADJUSTING THE DISPLAY CONTRAST
The contrast of the LCD can be adjusted. Adjust
for maximum visibility according to your viewing
environment.
PAG E
12
2 3 4
LEARN
123
4
LEARN
123
4
1.
Hold down the M button for three seconds or
more.
The menu is displayed.
2.
Press the > button to display the second page
SETUP menu.
3.
Press the D3 (CONT) direct button .
4.
Press the 3 or 4 cursor button and set the
display contrast for maximum visibility.
The adjustment has 10 levels.
The factory default setting for the contrast is the fi fth
level.
5.
Press the OK cursor button to enter the display
contrast.
6.
Once the setting is finished, press the M
button.