Filter
Top Products
ENGLISH
22
SETUP
After all components are connected, initial setup
must be performed.
ONSCREEN DISPLAY MENU SYSTEM
The SR7001 incorporates an onscreen menu system,
which makes various operations possible by using
the cursor (3, 4, 1 , 2) and OK/ENTER buttons on
the remote control unit or on the front panel.
Note:
•
To view the onscreen displays, make certain you
have connected the MONITOR OUT jack on the rear
panel to the composite, S-Video, component video
or HDMI input of your TV or projector. (See page
15, 16)
1.
Press the AMP button on the remote control
unit. (This step is not needed when operating
the setup menus from the SR7001.)
2.
Press the MENU button on the remote control
or press the MENU button on the front panel.
The “MAIN MENU” of the OSD menu system
is displayed.
There are 6 items in the MAIN MENU.
3.
Select the desired sub-menu with the
3
or
4 cursor buttons and press the OK/ENTER
button. The display will change to the selected
sub-menu.
Notes:
• If you desire to adjust any sub-menu, you need to set
it to UNLOCKED.
• To lock sub-menus, set items 1-6 on the MAIN
MENU to “LOCKED”.
<LOCKING SUBMENUS>
(1) Move the cursor to “1. INPUT SETUP” in the
MAIN MENU.
(2) Select the “0” mark left of “LOCKED” with the 1
or 2 cursor buttons.
4.
To exit from OSD menu system, press the
EXITbutton, or move the cursor to EXIT and
press the OK/ENTER button.
Note:
• Settings are entered with the ENTER button on the
unit or the OK button on the remote control unit.
When using the remote control unit, use the OK
button as if it were the ENTER button.
SR7001 FRONT BUTTON CONTROL
RC8001SR BUTTON CONTROL
2 31
5 64
OK
VOL
CH
PREV
MUTE
MENU
EXIT
GUIDE
TEST
CH.SEL
LIP·SYNC
SURR
7.1CH
ATT
SPK-AB
EXIT button
Press this button to exit the OSD
menu system.
MENU button
Press this button to display
the OSD menu system.
UP button
RIGHT button
DOWN button
OK button
LEFT button
MultEQ
ENTER
MENU
THX
7.1CH INPUT
AUTO
MULTI T-MODE
MEMORY
DISPLAY
EXIT
BAND
MIC
SPEAKER
MULTI
UP button
RIGHT button
DOWN button
MENU button
Press this button to display the
OSD menu system.
EXIT button
Press this button to exit the
OSD menu system.
LEFT button
ENTER button
AMP (Amplifi er) button
AMP
AUX2
AUX1
TAPE
TUNER
CD
CD-R
MD
12
LIGHT
Learning Remote Controller
RC8500SR