Filter
Top Products
57
ENGLISH
OPERATION OF THE MULTI ROOM OUTPUTS
WITH THE REMOTE CONTROL FROM MULTI A
Room A output can be operated from a room
where the receiver is not installed. This requires a
separately sold IR receiver. (For connections, see
page 12.)
D4
D5
D2
M
D1
D3
D5
USE
PAGE
123
4
D1
1.
1.
2 31
5 64
D4
D5
D5
OK
VOL
CH
PREV
MUTE
MENU
EXIT
GUIDE
TEST
CH.SEL
LIP.SYNC
SURR
7.1CH
ATT
SPK-AB
USE
PAGE
2
4
VOL
2.
2.
DSS
AMP
AUX2
AUX1
TAPE
TUNER
CD
CD-R
MD
VCRDVD
TV
12
LIGHT
Learning Remote Controller
RC8500SR
AMP
1.
1.
Press MULTI on the multi room remote control
from the MULTI ROOM.
(Press the AMP button and press the > button
until PAGE 4 is displayed. Press the MULTI
(D1) button.)
This operations will put the SR7001 into multi
room mode and “MULTI” will be illuminated on
the display.
MULTl ROOM Video out put will show OSD
information for the MULTI ROOM setup.
MULTI ROOM A
VIDEO :DSS
AUDIO :FM 102.00MHz
SLEEP :90 min
MONO/ST:STEREO
MULTI:OFF MAPKR:OFF
VOL :VARI VOL :VARI
LEVEL:-90dB LEVEL:-90dB
--- MAIN ROOM STATUS ---
VIDEO:DVD AUDIO:DVD
RETURN BACK EXIT
2.
Press the VOL+ or VOL− button on the
multi room remote control to set the desired
volume.
3.
In multi room mode, the multi room remote
control can be used in the multiroom to operate
the following functions.
General:
Controlling volume level, sleep timer, and muting.
SeIecting input audio and video source.
Tuner:
Selecting band, controlling preset channel up and
down, tuning up and down direct frequency call.
Notes for the Multi Room System
• The MULTI ROOM OUT (MULTl OUT/MULTI
SPEAKER) has analog outputs.
This does not support digital input signals.
• If the Tuner (FM, AM or XM) is active in the main
room, you can not control any function of the tuner.
In this case, You must listen to the same station as the
main room.
• When the component with RC-5 bus is connected
to the MULTI RC IN jack(see page 20), Multiroom
A can be operated using the RC codes for the main
room. The remote control units of other Marantz
products can also be used to control multiroom A.
(Room B output cannot be operated from another
room.)