Filter
Top Products
20
ENGLISH
1.
Select “CS II” in the SETUP MAIN MENU with
the or cursor buttons, and press the OK
button.
2.
To Select desired contents as below, press
the or cursor buttons.
TRUBASS:
Set the TRUBASS level between 0 and 6 level in
1 level interval with the
or cursor buttons.
TRUBASS produced by the speakers are an
octave below the actual physical capabilities of the
speakers adding exciting, deeper bass effects.
SRS DIALOG:
Set the SRS DIALOG level between 0 and 6 in 1
level intervals with the or cursor buttons.
This can be popped out of the surround audio
effects, allowing the listener to easily discern what
the actors say.
If “NONE” was selected for the Center speaker
setting, in the Speaker size set up menu, then this
setting will not appear.
After you complete this portion of the set up, move
cursor to “MAIN” with the or cursor buttons and
press the OK button.
7 MULTI ROOM
SR7400 has features in MULTI ROOM SYSTEM
such as source selector, OSD information, sleep
timer, Multi Room Speaker output and remote
control.
You can set these feature in this sub-menu.
1.
Select “MULTI ROOM” in the SETUP MAIN
MENU with or cursor button, and press
the OK button.
2.
To Select desired contents, press or
cursor button
VIDEO:
Select the video source of the Multi-room output
with
or cursor buttons.
AUDIO:
Select the audio source of the Multi-room output
with or cursor buttons.
4 SURROUND
1.
Select “SURROUND” in the SETUP MAIN
MENU with the or cursor buttons, and press
the OK button.
2.
To select a desired content , press the or
cursor buttons.
SURR.MODE :
Select the desired surround mode with the
or
cursor buttons.
HT-EQ :
Select to active the HT-EQ with the or cursor
buttons.
The tonal balance of a film soundtrack will be
excessively bright and harsh when played back
over audio equipment in the home. This is
because film soundtracks were designed to be
played back in large movie theater environments.
Activating the HT-EQ feature when watching a
film made for movie theaters corrects this and
restores the correct tonal balance.
The HT-EQ feature can be activated only while in
Dolby Pro Logic Mode, or while decoding Dolby
Digital or DTS encoded material.
LFE LEVEL :
Select the output level of the LFE signal included
in the Dolby Digital signal or the DTS signal.
Select 0 dB, -10 dB or OFF with the or cursor
buttons.
CHANNEL LEVEL
CENTER LEVEL:
Set the effect level of the center speaker between
–10 and +10 dB level in 1 dB level intervals.
• If “None” was selected for the Center speaker
setting, in the Speaker size set up menu, then this
setting will not appear.
SURR L LEVEL:
Set the level of the Surround left speaker between
–10 and +10 dB level in 1 dB level intervals.
• If “None” was selected for the Surround left
speaker setting, in the Speaker size set up menu,
then this setting will not appear.
SURR R LEVEL:
Set the level of the Surround right speaker between
–10 and +10 dB level in 1dB level intervals.
• If “None” was selected for the Surround right
speaker setting, in the Speaker size set up menu,
then this setting will not appear.
SURR BACK L LEVEL:
Set the effect level of the Surround Back L (left)
speaker between –10 and +10 dB level in 1 dB
level intervals.
• If “None” was selected for the Surround back left
speaker setting, in the Speaker size set up menu,
then this setting will not appear.
SURR BACK R LEVEL:
Set the effect level of the Surround Back R
(Right) speaker between –10 and +10 dB level in
1 dB level intervals.
• If “None” was selected for the Surround back right
speaker setting, in the Speaker size set up menu,
then this setting will not appear.
SUB W LEVEL:
Set the effect level of the subwoofer speaker
between –15 and +10 dB level in 1 dB level
intervals.
• If “None” was selected for the Subwoofer speaker
setting, in the Speaker size set up menu, then this
setting will not appear.
After you complete this portion of the set up, move
the cursor to “MAIN” with the
or cursor buttons
and press the OK button.
5 PL II (PRO LOGIC II) MUSIC
PARAMETER
Pro Logic II-Music mode creates a rich and enveloping
surround ambience from stereo sources such as CDs.
In this
mode, SR7400 includes three controls to
fine-tune the soundfield as follows.
Select “PLII
MUSIC
” in the SETUP MAIN MENU
with the or cursor buttons, and press the OK
button.
PARAMETER:
Select “DEFAULT” or “CUSTOM” with the or
cursor buttons.
If you select “CUSTOM”, you can adjust three
parameters as listed below.
PANORAMA:
Select the Panorama mode On or Off with the or
cursor buttons.
Panorama wraps the sound of the front left and right
speakers around you, for an exciting perspective.
DIMENSION:
Set the Dimension level between 0 and 6 level in
1 level intervals with the or cursor buttons.
Adjust the soundfield either towards the front or
towards the rear.
This can be useful to help achieve a more
suitable balance from all the speakers with
certain recordings.
CENTER WIDTH:
Set the Center width level between 0 and 7 in 1
level intervals with the
or cursor buttons.
Center Width allows you to gradually spread the
center channel sound into the front left and right
speakers.
At its widest setting, all the sound from the
center is mixed into the left and right.
This control may help achieve a more spacious
sound or a better blend for the front image.
If “None” was selected for the Center speaker
setting, in the Speaker size set up menu, then this
setting will not appear.
After you complete this portion of the set up, move
cursor to “MAIN” with the or cursor buttons and
press the OK button.
6 CS II (CIRCLE SURROUND II)
PARAMETER
4 SURROUND
SURR .MODE : AUTO
HT-EQ : OFF
LFE LEVEL : 0 dB
CENTER : 0 dB
SURR L : 0 dB
SURR R : 0 dB
SURR BACK L : 0 dB
SURR BACK R : 0 dB
SUB W : 0 dB
MA I N EX I T
5PL II MUS I C PARAMETER
PARAMETER : DEFAULT
PANORAMA : OFF
DIMENSION : 3
CENTER WI DTH : 3
MA I N EX I T
6CSII PARAMETER
TRUBASS : 0
SRS DI ALOG : 0
MA I N EX I T
7MULTIROOM
VIDEO : DVD
AUDIO : DVD
SLEEP TIMER : OFF
MULT I : OFF MSPKR :
✽✽✽
VOL :VARI VOL : ✽✽✽
LEVEL: - 90dB LEVEL : ✽✽✽
- ---MAIN-ROOM STATUS----
V IDEO:DVD AUDIO:DVD
MA I N EX I T
03.10.13, 9:25 AMPage 20