Marantz SR6400 Stereo Receiver User Manual


 
31
ENGLISH
ENGLISH
USING MACROS
The following procedure will show how to use the
function buttons for which you have programmed
macros.
1.
Press the Function button for the desired
macro for 3 seconds.
MACRO is displayed on the LCD for
approximately 1 second, after which the
number of steps in the macro is displayed
on the LCD.
The remote control will do nothing if no
macros are programmed. The macro steps
are executed in order and the names of
their buttons are displayed on the LCD.
Also, the step numbers displayed on the
LCD disappear as each step is executed.
2.
After all macro commands have been
transmitted, the remote control returns to AMP
in use mode.
EXAMPLES OF MACRO PROGRAMS
Example 1
Change the input source for the amplifier to CD
and play the 3rd track on a CD in the CD player.
1.
Press and hold the T.MODE and MENU
button until the MACRO is displayed on the
LCD.
LEARN and MACRO is displayed blinking.
2.
Press the CD Function button. CD-M is
displayed on the LCD.
3.
Press CD, 3 , and 3 buttons.
4.
When you are finished programming the
macro, press the OK button until the display
returns to USE mode.
Now, execute the macro you just programmed.
1.
Press the CD Function button for 3 seconds.
The macro commands are transmitted to
the components in order, and the steps of
the operations are displayed on the LCD in
order.
Example 2
Turn the main amplifier ON Change the
amplifiers input source to DVD Set the Surround
mode to VIRTUAL Set the DVD player to PLAY.
1.
Press and hold the T.MODE and MENU
button until the MACRO is displayed on the
LCD.
LEARN and MACRO are displayed blinking.
2.
Press the DVD Function button .
Here the DVD Function button is used as
the macro button, but any function button
can in fact be used.
3.
To set the various steps of the macro, press
the following buttons in order:
(1) AMP* (2) POWER ON (3) DVD (4)
AMP* (5) 8 (VIRTUAL) (6) DVD* (7)
3 .
4.
When you are finished programming the
macro, press the OK button until the display
returns to USE mode.
Now, execute the macro you just programmed.
1.
Press the DVD Function button for 3 seconds.
The macro commands are transmitted in
order, and the steps of the operations are
displayed on LCD in order.
When executing this macro, function
operations AMP* and DVD* only switch the
command set of the remote controller and
no signal is transmitted to the component.
CLEARING MACRO PROGRAMS
The following procedure is used to erase macros
you have programmed into the remote controllers
memory.
1.
Press and hold the T.MODE and MENU
button until the MACRO is displayed on the
LCD.
LEARN and MACRO are displayed blinking.
2.
Press and hold the CL button, then press the
button for the Function to be cleared (in this
case DVD) for 3 seconds.
DVDCL will appear on the LCD.
(1)
(3)
(2)
(5)
(2)
(1) (4)
(3) (6)
(7)