Filter
Top Products
English
English
Français
Français
9
TAPE DECK CD-R/MD OPERATION
TO PLAY BACK FROM A TAPE
1. Press TAPE A to the indicator above the switch is lit.
2. Play a tape on the tape deck.
3. Use VOLUME B to adjust volume.
4. Use BASS and TREBLE D to adjust the tone.
NOTE:
You can play back from a tape regardless of the INPUT
SELECTOR C setting.
TO RECORD TO A TAPE
1. Set INPUT SELECTOR C to PHONO, CD, TUNER, AUX
1, or AUX 2 to select the source you want to record from.
2. Use the REC SELECTOR E (see below) to specify the
type of recording you want to perform.
3. Start play on the selected source.
4. Perform the applicable operation on the connected tape
deck to record the output from the selected source.
USING THE REC SELECTOR
Use the REC SELECTOR E to specify the type of recording
you want to perform.
1. The OFF setting cuts off all signal output from the REC
OUT jacks. Note that REC SELECTOR E should normally
be in the OFF setting except when you are recording to
tape. The OFF setting shortens the signal path within the
amplifier, which minimizes crosstalk and other factors that
can cause deterioration of the sound.
2. SOURCE sets up for recording the signal from the source
selected by INPUT SELECTOR C.
3. COPY sets up for recording from TAPE to CD-R, or from
CD-R to TAPE. You can listen to the output from another
source while recording in the COPY position by selecting
the source you want with INPUT SELECTOR C.
NOTE:
The SOURCE DIRECT switch must be turned off (raised)
in order to record to a tape deck. Recording will not possible
when SOURCE DIRECT is turned on (depressed).
PERFORM THE APPLICABLE OPERATION ON THE
CONNECTED TAPE DECK.
INTEGRATED AMPLIFIER PM7000
INPUT SELECTOR VOLUME
POWER ON/OFF 1 2SPEAKERSSTANDBYPHONES
OFF
REC SELECTOR
TAPE PHONO CD
TUNER AUX1 AUX2
TAPE
CD-R/MD
CD-R/MDMUTE
BASS
SOURCE
SOURCE DIRECT
OFFONOFFON
+
-
R
L
+
-
TREBLE BALANCE
MAXMIN
COPY
TAPE CD-R
CD-R TAPE
AC
B
ED